The purpose of this paper was to investigate the two-dimensional ferrofluid flow and heat transfer of ferrofluid past a nonlinearly stretching sheet with suction/injection with

The regions with higher heat flux coincide with oceanic ridge system, the heat flow over average value is due to convection.. There are low heat flow values over ancient part

In case of tubular flow, the value of the convection heat transfer coefficient is much larger, than the value in laminar flow, so we have to create tubular flow.. The

Abstract: In the present study, fully developed laminar flow with forced convection heat transfer of Al 2 O 3 /water and TiO 2 /water nanofluids inside a vertical

Heat and Mass Transfer of a Peristaltic Electro-osmotic Flow of a Couple Stress Fluid through an Inclined Asymmetric Channel with Effects of Thermal Radiation and Chemical

Malapati and Polarapu [12] pre- sented the unsteady MHD free convective heat and mass transfer in a boundary layer flow past a vertical perme- able plate with

But the most physically relevant investigation is the change of the heat transfer in condenser depending on the refrigerant mass flow rate and the heated water mass flow

The fluid flow and heat transfer characteristics, i.e., dynamic pressure coefficient, stream function, mean, axial, and transverse velocities, turbulent viscosity, temperature

The selection of alkali metal working fluids for Rankine cycle space power systems has necessitated investigation of two-phase heat transfer and fluid flow characteristics.. The

Numerical simulation has been conducted for analysis the impact of the nanoparticles on the heat transfer properties, on the temperature and velocity profiles, on the wall

circulation at the hub. The fluid is considered as incompres- sihle, frictionless and without heat transfer. HowELL [4] obtains the solutioll of three-dimensional flow

HECTIC-II calculates the pressure drop along the coolant channels, axial flow rates, heat transfer rates, rod surface and coolant temperatures in gas - cooled or single

Baffles used in the shell side to improve the heat transfer and cause turbulent flow, while in the tube side will be laminar in this

In this study flow around and heat transfer from an elastically supported cylinder is investigated using a newly extended computational code.. In order to investigate its accuracy,

The definition of heat transfer coefficients and the knowl- edge of heat that is removed at every second - that is calculated by using the heat transfer coefficients - are

Lehetséges, hogy a kétoldalú megállapodást megelőzi valamelyik fél részéről a felmondás és ekkor következőkép kell disztingválnunk: ha én, mint felmondó fél

With the help of the heat resistance models, the surface heat transfer coefficient and the meteorolgy models, I have developed a complex energy prediction system, and

The high degree of warming up of the fluid in compact heat exchangers owing to the high thermal output, brings about a very considerable temperature difference in the