• Nem Talált Eredményt

Biolubricant production in ionic liquids by enzymatic esterification

N/A
N/A
Protected

Academic year: 2022

Ossza meg "Biolubricant production in ionic liquids by enzymatic esterification"

Copied!
1
0
0

Teljes szövegt

(1)

HUNGARIAN JOURNAL OF INDUSTRIAL CHEMISTRY Vol. 39(3) pp. 395-399 (2011)

T. Bányai, K. Bélafi-Bakó, N. Nemestóthy, L. Gubicza

BIOLUBRICANT PRODUCTION IN IONIC LIQUIDS BY ENZYMATIC ESTERIFICATION

395 Esterification of oleic acid with short carbon chain alcohols gives biofuels, with long

chain alcohols biolubricants can be produced. Previously biolubricants was successfully produced from fusel oil and isoamyl-alcohol substrates by enzyme catalised

esterification, but solution of polar substrates was problematic, that was solved by using ionic liquids. The optimal reaction parameters such as substrate molar ratios, initial water content, amount of enzyme and type of ionic liquid were determined by

experimental design using Statistica software. Some of the ionic liquids have catalytic effect by itself, therefore control reactions were necessary to determine which ionic liquid has negligible catalytic effect. In five of the six investigated ionic liquid the yield was the same without enzyme, while in case of B[mim]PF6, the yield was negligible. In shorter time higher yield was achieved in presence of ionic liquid against other

methods. Increasing the temperature results higher yield till a limit, higher temperature does not make moreproduct, but thermal desactivation of the enzyme was not occur.

Hivatkozások

KAPCSOLÓDÓ DOKUMENTUMOK

The change in enzymatic activity of the immobilized enzyme at different values of pH and temperature, as well as stability over time, was measured.. The results

The nutrient doses higher than N130PK30 did not increase the yield of wheat.. The number of spikes/m2 was 564.67 in

From an ecosystem service aspect, the surface temperature does not represent the total effect of urban trees and green spaces on human thermal comfort, and the spatial resolution

The absorbed energy in the interface of the solution and the ftised silica increases when increasing the absorption coefficient resulting in higher temperature liquid layer at

At higher styrene content (15%) at a higher temperature (190°C), reduction in absorbance ratio D998/D973 was still more emphasized a bit but the experimental data led to

Inhibitor binds to an other active site of the enzyme and does not affect the binding of the substrate – does not change the affinity of the enzyme to the substrate.. Here a proton

Inhibitor binds to an other active site of the enzyme and does not affect the binding of the substrate – does not change the affinity of the enzyme to the substrate.. Here a proton

black locust trees showed higher variability, and most of the samples did not show increasing values, only in case of a few samples increasing sensitivity was ob- served