• Nem Talált Eredményt

CAD/CAM/CAE elektronikus példatár - Alkatrész-modellezés 5.

N/A
N/A
Protected

Academic year: 2022

Ossza meg "CAD/CAM/CAE elektronikus példatár - Alkatrész-modellezés 5."

Copied!
2
0
0

Teljes szövegt

(1)

www.tankonyvtar.hu Molnár László TÁMOP 412-08-2-A-KMR-2009-0029

Part 05 - exercise

Part modeling (sweeping) Assignment: Create the model of the part shown in the figure below!

Assignment aim: Getting to know the sweeping command.

Sketch preparation, work plain, sweeping.

1) Start a new problem, create the basic adjustments considering the shape and dimensions of the part to be prepared.

2) Create the course of the sweeping. Apply the poly line command and check the complete existence of the geometric constraints.

3) Take a work plane at the starting point of the route, perpendicular to the route! Fit a sketch plane on the work plane and draw the wire cross section (diameter 0,99) of the clip binder!

(2)

Part 05 – Part modeling (sweeping) − 2 − Program independent

www.tankonyvtar.hu Molnár László TÁMOP 412-08-2-A-KMR-2009-0029

4) Create the part by sweeping.

Home work: Prepare a clip binder having a bent inner part.

Hivatkozások

KAPCSOLÓDÓ DOKUMENTUMOK

3) Vegyen fel egy vázlatsíkot a kocka bal oldali homloklapján, majd válassza az Insert Image parancsot!.. Ez után mutasson rá a kocka bal fels ő sarkára, és a piros pont, vagy

El ő ször egy olyan munkasíkot kell létrehozni, amelyik keresztül- megy a korábban felvett munkatengelyen, és az XZ síkkal 45º-t zár be (Work Plane5), majd ezt a síkot

Assignment aim: To be acquainted with the most significant applications and commands of the program through the modeling of a simple part. Sketch preparation, geometric

Assignment aim: Extending the knowledge regarding the program application through modeling of a simple part. Sketch preparation, automatic geometric constraints,

Assignment aim: Extending the knowledge regarding the program application through modeling of a simple part. Sketch preparation, centerline, applying constructing

Assignment aim: Viewing the application of the work features, (the work plain, the work axis and the work point), related procedures and commands. Sketch

Számítsa ki az elméleti szállítómagasságot (22,9 m) és rajzolja meg léptékhelyesen az átlagos kilépő sebességi háromszöget.. 400 mm átmérőjű járókerék

HajlításiSugár megad á sa (1,25mm).. KicsípésSzélesség megad á