• Nem Talált Eredményt

Tekla S ary �

N/A
N/A
Protected

Academic year: 2022

Ossza meg "Tekla S ary �"

Copied!
1
0
0

Teljes szövegt

(1)

journal of the mechanical behavior of biomedical materials xxx (xxxx) xxx

Please cite this article as: Tekla Sáry,journal of the mechanical behavior of biomedical materials, https://doi.org/10.1016/j.jmbbm.2019.103505 1751-6161/© 2019 Elsevier Ltd. All rights reserved.

Corrigendum

Corrigendum to “ Fracture behaviour of MOD restorations reinforced by various fibre reinforced techniques – An in vitro study ” [J. Mech. Behav.

Biomed. Mater. 98 (2019) 348 – 356]

Tekla S ary �

a

, Sufyan Garoushi

b

, G � abor Braunitzer

c

, David Alleman

d

, Andr as Volom �

a

, M � ark Fr � ater

a,*

aDepartment of Operative and Esthetic Dentistry, Faculty of Dentistry, University of Szeged, Szeged, Hungary

bDepartment of Biomaterials Science and Turku Clinical Biomaterials Center -TCBC, Institute of Dentistry, University of Turku, Turku, Finland

cDicomLAB Dental Ltd., Szeged, Hungary

dThe Alleman Center for Biomimetic Dentistry, Utah, USA

The authors regret that the figures in Table 2 got mixed up after adjusting the order of the tested groups. This mistake is only present in Table 2., and does not affect the discussion or the conclusions drawn.

Please find attached the corrected Table 2 in order to aid the interpre- tation of our results.

The authors would like to apologise for any inconvenience caused.

Table 2

Significance matrix from the post-hoc pairwise comparisons (Tukey’s HSD). The conventions are the same as in Table 1. Empty cells indicate lack of significance.

Group 1 Group 2 Group 3 Group 4 Group 5 Group 6 Group 7 Group 8 Group 9 Group 10 Group 11 Group 12

Group 1 0.000 0.033

Group 2 0.041 0.005

Group 3 0.041 0.001 0.000 0.009 0.000 0.000 0.002 0.000 0.000

Group 4 0.0023 0.049 0.007 0.000 0.000

Group 5 0.001

Group 6 0.000 0.023

Group 7 0.009 0.026

Group 8 0.000 0.049

Group 9 0.000 0.007

Group 10 0.002

Group 11 0.000 0.005 0.000 0.000 0.026

Group 12 0.033 0.000 0.000

DOI of original article: https://doi.org/10.1016/j.jmbbm.2019.07.006.

* Corresponding author. Department of Operative and Esthetic Dentistry Faculty of Dentistry, University of Szeged, Tisza Lajos Krt. 64-66, H-6720, Szeged, Hungary.

E-mail address: meddentist.fm@gmail.com (M. Fr�ater).

Contents lists available at ScienceDirect

Journal of the Mechanical Behavior of Biomedical Materials

journal homepage: http://www.elsevier.com/locate/jmbbm

https://doi.org/10.1016/j.jmbbm.2019.103505

Hivatkozások

KAPCSOLÓDÓ DOKUMENTUMOK

In our study, teeth restored with cuspal coverage restorations (Groups 1 and 2) showed slighty higher fracture resistance com- pared to the direct filling groups (Groups 3 and 4) at

After adhesive treatment and rebuilding the missing interproximal walls with composite, the specimen were restored with different fibres and a final occlusal layer

Panel tests better represent the ductility of fibre reinforced concrete specimens, the beam test does not represent the real fibre concrete composite performance during the ageing

In this present study, the in vitro action of chlorpromazine, trifluoperazine, valproic acid and amantadine individually and in combination with amphotericin B were

This study herein presents investigations about behavior of circular flange bolted connection (CFBC) in ultra high performance fiber reinforced concrete (UHPFRC) hollow

Design of the steel ~ire reinforced concrete cross section In the uncracked condition of steel ·wire reinforced concrete, wires exhi- bit stresses low compared

The thread cutting process of threaded joint between metal screw and short glass fibre reinforced polymer part (PAGF30) was modelled by the Finite Element Method in order to

This study provides a framework for investigating the seismic response of an elevated steel water tank within a reinforced concrete chimney, to assist optimal tank placement