The eutectic temperature registered during the analysis was compared with the eutectic temperature of the unmodified alloy and on the basis of the differences between the

Therefore, the fracture surface of Al-Si alloys is creating with ductile fracture of matrix and cleavage fracture of hard and brittle structural components (eutectic Si

Based on the results of measurements, the evaluation was oriented to the curve of roughness, the functionality of surface roughness R a and the necessary quantity of the shot

%UHHGHUV LQ &URDWLD ZDV HVWDEOLVKHG DQG WRGD\ WKHUH DUH DERXW +ROVWHLQ KRUVHV LQ SULYDWH EUHHGLQJ ,Q WKH SHULRG RI \HDUV RI WKH .ULåHYFL +ROVWHLQ KRUVH EUHHGLQJ SURJUDPPH

The EDS (energy dispersive detector, EDS) results indicated that these fine fragments mainly consisted of Si, Al, Fe, Mg and K, which when considered together

[r]

Indeed, if these resonance strengths (and of the one at 71.5 or at 84 keV in particular) were found greater than the established upper limit, the 27 Al(p, α) 24 Mg reaction rate

This trend means that Fe atoms in off- stoichiometric Fe-Al alloys with excess Fe atoms sitting on Al sites have magnetic moments and the number of magnetic Fe atoms can be

This study is a research on the impact of nitrogen from a controlled atmosphere during production and investigations of Cu-Zr-Al(-Ag) master alloys that are forerunners for

hogy bizonyos nemzetbeli munkás miképen osztja fel a jövedelmét, akár az élelmezés, lakás, fűtés, világítás, akár a ruházat költségeit tekintjük, nem is említve az

Also a correction due to the field dependence of the second order quadrupole effect was estimated from the field dependence measured on high concentration Al-Zn alloys

Fe hyperfine fields with similar structure were observed in off-stoichiometric B2 ordered Fe – Al alloys and the high- field peak (shaded area in Fig. 3a) was attributed to Fe

Yet, the major problem of amorphous metal alloys is their metastable character, these alloys being used only at low temperatures, but by introducing crystalline copper in

Composition depth profile of d.c.-plated ternary Ni-Co-Fe alloys obtained from a stagnant solution For binary alloys, it was clear that the metal with high deposition

The behavior of the other alloys studied shows similar trends, however a wider temperature range of constant per- meability can be observed for the nanocrystalline samples of the

A kedvező humusztartalom mellett jó tápanyag-ellátottságú talajok (N%, AL-P) voltak a város területén, melyhez alacsony AL-K, egyenletes KCl-Ca, KCl-Mg

Low temperature and high field measurements were performed on nanocrystalline FeZrBCu alloys, on ball-milled Fe with nano-size grains and on melt-quenched amorphous Fe–Zr and

Short-range order in Fe-B metallic glass alloys